The welding roller frame is widely used, especially for the welding of stainless steel pressure vessels.
It is also called welding rotators,welding positioners,etc.
First of all, as a special type of container, stainless steel pressure vessels should be strictly separated from carbon steel products.
If the stainless steel pressure vessel is attached with carbon steel parts, the manufacturing site of the carbon steel parts shall be separated from the stainless steel.
In order to prevent the pollution of iron ions and other harmful impurities, the stainless steel pressure vessel production site must be kept clean and dry, and the ground
should be covered with rubber or wood flooring.
Secondly, during the manufacturing process, sharp and hard materials should be avoided from scratching the surface of stainless steel.
If there are local bumps or scratches on the surface of the stainless steel pressure vessel that affect the corrosion performance, it must be repaired.
To ensure the quality of stainless steel products, to ensure the performance of the equipment and extend the service life.
Therefore, the outer surface of the welding rotator must be cleaned before using.
All transmissions should be regularly checked for lubrication.
In the process of lubrication and use, avoid foreign matter from falling into it.
Turn on the switch to start the motor for a trial run, and observe whether all parts are running normally.
Work can only be carried out after confirming that there is no problem.
During installation, the height and longitudinal position of the roller frame of the main and follower are required to be set.
If it is not placed properly, the weldment will be displaced during rotation. Always pay attention to the hygiene around the equipment.
Make the equipment work normally in a clean and clean environment.
For more questions, please consult Dongtai Yaoqiang Machinery Manufacturing Co., Ltd., welcome your calls and visits
