1. The self-adjusting roller frame should be installed in a sturdy, ventilated, rain-proof, moisture-proof, dust-proof, and far away from severe vibrations and bumps. It is strictly forbidden to spray corrosive liquids on the equipment.
2. It is strictly forbidden to spray corrosive liquids on the equipment. When the main and driven roller frames are installed at the same time, it is necessary to ensure that the level of the main and driven frames are equal, and the center line is on the same straight line, and the diagonal line of the main and driven frames is measured for adjustment.
3. Requirements for placing the workpiece: The diameter and weight of the workpiece should be strictly in accordance with the design regulations, otherwise safety accidents may occur. Adjust the distance between the main and auxiliary wheels appropriately according to the length of the equipment.
4. The rubber wheel is only suitable for working at room temperature. In special circumstances, the maximum temperature of the contact between the workpiece and the rubber wheel is not allowed to be higher than 75 degrees, otherwise the rubber wheel may be damaged.
5. When in use, the roller should fully contact the workpiece, and it is strictly forbidden to contact the weld or sharp parts. At the same time, when lifting the workpiece, it is strictly forbidden to hit the roller to prevent the roller or other parts from being damaged. If the equipment is not fixed, a strong impact is very likely Leading to the subversion of the whole machine.
6. The debugging roller frame is gradually adjusted from low speed to high speed when starting. When changing the direction of rotation, the motor can only be switched after the motor stops, otherwise it is easy to cause the motor to burn. During operation, it is strictly forbidden to separate human and machine, and it is strictly forbidden to stand within the radius of rotation of the workpiece.
7. In order to ensure the performance of the equipment, the transmission parts should be filled with enough lubricating oil before use, and the equipment should be filled in the daily maintenance record form. After the whole machine has been used for a period of time, it should be checked regularly and the maintenance record form should be filled in.
8. The equipment uses a three-phase 380V AC power supply. The power supply line must pass through an air switch for safe operation. When the equipment is debugged, turn on the power supply, press the start button, and observe the rotation of the driving wheel. Whether the speed adjustment is normal. If there is an abnormality, The power should be cut off immediately and the cause should be found. Only after troubleshooting, can the machine be powered on again and tested.
9. Check and remove the obstacles on the device before use, and it needs to be used and kept by a dedicated person. Do not contact with oil and fire on the roller frame unit (rubber wheel).