1. The operator has to understand the fundamental structure and performance of the machine, reasonably choose the scope of application, grasp the operation and protection, and understand the common sense of electrical safety.
2. When the cylinder rests on the roller frame, it is necessary to check whether the base line of the supporting roller and the base line of the cylinder are parallel to ensure that the contact between the supporting roller and the cylinder is evenly worn.
3. Adjust the focal length of the two sets of Torun bases to be 60 degrees ± 5 degrees from the base of the cylinder body. If the cylinder body is overweight, protective equipment should be added to prevent the cylinder body from stringing out when it rotates.
4. The conditioning roller frame is carried out under the state of machine blocking.
5. When starting the motor, first close the two-pole switch in the control box, turn on the power supply, and then press the "forward" or "reverse" button according to the welding request. To abort scrolling, press the "Abort" button. If you need to change the direction of rotation in the middle, you must press the "stop" button to adjust the direction, and turn on the power supply of the speed control control box. The speed of the motor is controlled by the speed control knob in the control box.
6. When starting, adjust the speed control knob to the low speed position to reduce the starting current, and then adjust the speed to the required speed according to the operation requirements.
7. In each activity section. Each shift needs to be filled with lubricating oil, and it is also necessary to regularly check the lubricating oil in each turbine box and the bearing; the bearing lubricating oil is recommended to use ZG1-5 calcium-based lubricating grease, and the method of frequent replacement is adopted.