When using a laser cutting machine, it is necessary to pay attention to many details.
A good grasp of the laser cutting machine's use skills and daily maintenance can make the equipment more efficient and use more worry-free.
Daily maintenance:
The guide rails should be cleaned frequently to remove dust and other debris to ensure the normal operation of the equipment.
The rack should be wiped frequently and lubricated to ensure lubrication without debris.
The guide rails and motors should be cleaned and lubricated frequently, so that the machine can move better and cut more accurately while moving, and the quality of the cut products will be improved.
2. Clean the water tank and replace the circulating water once a week.
The quality and temperature of the circulating water directly affect the service life of the laser.
It is recommended to use pure water and keep the water temperature below 35°C. If it exceeds 35℃, the circulating water needs to be replaced, or ice cubes are added to the water to reduce the water temperature (it is recommended that users choose a cooler or use two water tanks).
3. Long-term use of the fan will accumulate a lot of solid dust in the fan, make the fan a lot of noise, and it is not conducive to exhaust and deodorization.
When the fan suction is insufficient and the smoke is not smooth, turn off the power first, remove the air inlet and outlet pipes on the fan, remove the dust inside, then turn the fan upside down, and pull the inner blades until they are clean , And then install the fan.
4. Different laser cutting machine equipment has different operations. Do the corresponding training before operation and strictly follow the laser cutting machine operating procedures.
Precautions when using
1. Spacing between parts: Generally, when cutting thick plates and hot plates, the spacing between parts should be large.
Because the heat of the thick plate hot plate has a great influence, when cutting corners and small graphics, it is easy to burn edges and affect the cutting quality.
2. Co-edge cutting: Co-edge two or more parts into a combination. Large quantities of regular graphics should be co-edge as possible.
Co-edge cutting can greatly shorten the cutting time and save raw materials.
3. Check the straightness of the track and the verticality of the machine every six months, and maintain and debug if it is abnormal.
Otherwise, the cutting effect may be affected, the error will increase, and the cutting quality will decrease.
