1. Follow the welder's safety operating procedures.
2. When installing and disassembling the workpiece, check whether the circular pressure plate has been taken out and whether the pressure plate has been retracted to prevent the workpiece from damaging the fixture.
3. When hoisting the workpiece, it must be stable and level, without large swings, to prevent the workpiece from colliding with the fixture, so as not to damage the fixture.
4. When hoisting the workpiece, the sling must be properly installed before the sling can be removed from the workpiece.
5. When disassembling the workpiece, the workpiece must be hoisted firmly with a sling before the workpiece can be loosened.
6. When the workpiece falls on the fixture, it should be handled gently, and there should be no excessive impact on the fixture and the positioner.
7. The installation of the workpiece must be positioned as required, all the nuts and bolts of the fixture must be tightened, and the pressure plate must be pressed tightly. After the installation is completed, a trial run is required to check, and the formal operation can be performed after the installation is confirmed.
8. Before turning, check whether there are other objects in the working turning range to avoid collision.
9. After the workpiece is turned to the working position, the power switch must be turned off and the power supply must be cut off to prevent malfunction.
10. Pay attention to the work center when installing the workpiece, and not deviate from the center of gravity.
11. Do not carry overweight or overload.
12. When the workpiece needs to be ascended and welded, the ascending pedal must be used, and the ascending pedal must be placed securely before ascending operation. Involving the user's concept of equipment and equipment, and considering different uses for handle welding and automatic welding, when selecting and designing a welding positioner, in addition to the main degree of freedom, it is also necessary to consider increasing the auxiliary degree of freedom.