1. Check whether the clamping block, steel belt and guide wheel are loose or the steel belt is loose.
2. Check all parts of the transmission for looseness, check the meshing of gears and racks, and adjust if necessary.
3. Check whether there is rubbish at the main air inlet and whether each valve and pressure gauge are working properly.
4. Check whether all air pipe joints are loose and all pipes are not damaged. Tighten or replace if necessary.
5. Loosen the tightening device and push the pulley by hand. If it comes and go freely, adjust or replace it in time if there is any abnormality.
6. Check the power cabinet and operation platform, whether the fastening screws are loose, use a vacuum cleaner or a blower to clean the dust in the cabinet. Check whether the wiring head is loose.
7. Check the performance of all buttons and selector switches. Highly intelligent automatic cutting equipment, so you should pay attention to diligent maintenance and diligent maintenance in daily operation, use, and maintenance.https://www.wxsilvercoast.com/